Looks nice and clean...
I'm not an expert lol but in my opinion i think you should experiment a little bit with the line tools in whatever programme you use...
That was the advice Bojan gave to me when i first started out and it has stood me in good stead....
I also think it would be worth experimenting with the colours of the sponsors...if you get them from brands of the world.com you can open them rather large and then easily change the colours before re-sizing....
I'm not sure the red works on the rear wing...in the grand scheme of things....
As much as it pains me to agree with Gui :p try not just colouring in the different bits of the template. For a first job though it is quite good and i like the general colour scheme...just a minor nitpick...but aren't alpine/pioneer/ phillips all electrical makers?? I doubt you'd get them on the one car :p
maybe put heineken with a green background going down the back of the engine cover, and then use a thickish white line, say siz 5/6 to seperate it from the blue....you can then add this colour scheme (green+heineken/white/blue) to the rear wing...
As with regards to the nose, maybe try and incorporate the blue into the sides...maybe change it round so the top of the nose is white, not blue, and then incorporate a design so that the sidepods run from blue into the white...not necessarily blended but using curves if you like...
Jus my suggestions hope i make sense...all looks good so far
thumbs up!!
Please click my sig!