ZModeler

I'm making a car and I have some little problems with the surfaces.

If I start making (for exemple a sidepod), I always go to surfaces ==> flat, and than I give the values I want

But, if I maybe a sirface, started the sidepod, and I see I've not enough polys to finish it, I ahve to make a new flat surface, and NEARLY attach the polys, for that we won't see any space between the 2 surfaces, or I begin again with more polys in the surface.

Now I have a question, is it possible with a tool to realy ATTACH the polys?

For exemple, I make a surface wtih 4 polys, and than again 1 with 4.

So I have 2 surfaces. is it possible to attach the polys, so that I have 6 polys?

Is this possible?








Edited 1 time(s). Last edit at 03/07/2005 06:01PM by laurent.

yes.

He might want an explanation nick

Just go create, faces, single. and have a go using that

---

ok, I'll try it out, this would make my "job" better, and faster!!

god knows how u could even try and make a car not knowing how to create single faces